AC is the magnitude of sinosudial-wave but we use cose value to determine power factor instead of sine value.
Answer Posted / sarmadahmed
SINE and COSINE are both sinusoidal. They essentially have same properties but different values at different time but both are sinusoids and every wave having similar properties will be a sinusoid too. And the cosine term is there because of some trigonometric calculations, it could be sine too. Have a look at power triangle and you'll get the answer.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to Calculate KA Rating of Main LT Panel
what is draiv work
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
what is model question rrb junior engineer electrical gr.II
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
what will happen if ac and dc supplies given
What would be the size of wire used for 2 Ton of window A.C?
electrical ques
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Can you explain about pole discrepancy scheme
If any cable burnt how can we identify it burnt by high current of high voltage?
How a band pass filter is constructed?