Answer Posted / ashok
Universal Motor because it can be used for A.C as well as D.C Supplies. So, Universal Motor is used in Mixies.
Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
what kvrah y we need to take the readind of that
What is transmittance?
What are the advantages of instrument transformer?
is oil viscosity affect on motor current?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
How many types of electrical earthing are there?
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
what is harmonics? what are the factors it will depend upon
What is principle of Floroscent tube 36watt.
what are the difference between PLC and embedded
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?