Answer Posted / bathan
Wrong question
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
what is the metal ratio in granular subbase coarse for one cum ? And please explain the morth table ...what is the difference between grading 1 , 2, 3 what it means..plz explain
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
how many minimum admixtures are used in water froofing structures
What do you meant by gui?
how ratio is calculated for any grade of concrete. for e.g. sppose M20 requires(x;y:z) quantity of cememt sand and aggregate.
03. a. The water cement ratio for achieving maximum strength of concrete is…… 1 b. Water/ cement is inversely proportional to-------------- 1 c. Increasing the slump decreases the strength: True / false 1
how many digree of freedom in four bar chain
1)Why we can use half brick in 4inch wall and 2)why not in 9+inch brick wall
Normally in slabs, steel quantity is not added when you calculating concrete quantity for that slab, why it is not added ?
How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 600 microns?
why steel tanks are provided (a) for water pressure (b) for wind pressure (c) for earthquake pressure
at which depth the construction of tunnel is economical from cost and engineering aspect.
What is zoning permit?
why do we provide haunches in rcc box or underpasses?
How Can I know the wastages(%) of each work added in estimating the quantity of construction materials?(Eg. Ceiling Work, Brick Work,etc....)
