Why Trasformers rated in KVA
- 13 Answers
- 16072 Views
- College School Exams Tests, HAL, Oil and Gas Jobs, I also Faced
- E-Mail Answers
Answer Posted / jey
Transformers and Generators are rated in KVA bcoz PF cannot be calculated( Cu loss depends on Voltage & Iron loss depends on Current). Always the Source end i.e transformer , Generator, power factor cannot be calculated and it is rated as KVA and Destination end i.e is Utility side such as Motor are rated as KW
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how freewheeling diode improves the powerfactor
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
how can i get the formula to find out the cable size if i know the load of main fuse protection.
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
What is DC series motor?
How stabilizer works??
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
What is conventional thermal current (Ith)
What is the suitable transmission voltage?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
what is meant by skew width in machines?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
State superposition theorem?
