Answer Posted / raul
Over voltage, over current, over speed, reverse power, over flux, loss of excitation. These r d major protection required for a synchronous generator.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
When lag/lead/lag-lead compensation is employed?
Describe the control mechanism of missile launcher???
what happen ehen synchronisation is done at below rated speed
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
How to measure the Harmonic Distortion of UPS ie THD?
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
how to calculate
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
what are the protecyion of transformer & generators
What is the difference between solid grounding and impedance grounding?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
how pt is using
why star point of HT motor not earthed?