what is the difference between 3,4 wire RTD sensor?
- 6 Answers
- 14506 Views
- HTA Instrumentation, I also Faced
- E-Mail Answers
Answer Posted / dinesh priyadarshi
RTD are used as 3 wire and 4 wire combination for following
reasons :
1) Lead wire compensation requird because this reduce the
error produce by the wire resistance
2) The distance also increae the error so to reduce the
errors we r using 3rth wire for lead compensation.
3) 3 wire and four wire lead compensation increase the
accuracy by means of resistance
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Capacitance, resistance ( colour coding ), parallel & series circuits.
please send the sample qustion paper for iocl written test ..
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
Why MUX JB's are using only Temperature Element in Fundation field bus?
How it the difference between force balance system and dispalacement balance system?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
What is the reason PT speed not incresed in gas turbine?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
Explain the difference between mmwc and mmwg?
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
