Interested to Buy Any Domain ? << Click Here >> for more details...
How Negative Phase Sequence Relay works in case of
Synchronous Motor?
- 4 Answers
- 31675 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / 32r
deeepak patidar the questin is regarding syn. motor so pls make it clear
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What is principle of Floroscent tube 36watt.
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
why r we using shell transformer for low voltage
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
Difference between low impedance and high impedance Restricted Earth Fault
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
difference between semiconductor & conductor & insulator?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
How to check the Bushings of the transformer?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
what is W.T?specify the acceptable range?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how to get bearing & winding temperature of an induction motor?
