Answer Posted / manish
top bar- at middle of the suppot
bottom bar-at end of the support
lap should be 50d as per is13920
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
Define What is diversion tunnel in a dam?
Can anybody help by describing each and every step in short, used while giving a building layout by total station? Regards
Explain what are the problems one might face while having a Cantilever balcony?
What is rate of concrete surface rendering work per sqm
Design a cantilever slab to carry a live load of 2000 N/m2. The overhang of the slab is 1.20m. b) A slab over a room is 4.75m x 4.75m. The edges of the slab are simply supported and the corners are not held down. The live load an the slab is 300 Kg/m2. The slab has a bearing of 15cm. On the supporting walls. Design the slab as per Rankine - Grashoff theory. Assume weight of R.C.C. = 2400 Kg/m2.
quantity of material needed for rubble stone masonry for 1:4 and 1:6
Explain how you can turn off the display for dimension in CAD?
I want to know the material required per Square foot in rcc roof i.e.Steel ,Cement,
Laying bitumen concrete 40mm thick using 0.1372 cum of 13.2 10mm metal ,0.2387 cum of 10 5mm metal...what did it means please explain me how much cum of 10 mm metal need?
why should we use 20mm graded metal only in vrcc?why we shouldnot use 40mm metal?
material used for mendrel use to bend epoxy coated rebar
what is zone a n zone b?why the spacing of ring in zone a less.n zone b high?
why are you joining in this (applied post) job and your aim for this job
how i can calculate the actual nos & size of steel to make 1000sqft. x 3"thick slab
