for columns reinforcement the lap length is not provided then
how to rebar the rods then how rebar should be lapped
- 4 Answers
- 11676 Views
- Nagarjuna Construction, I also Faced
- E-Mail Answers
Answer Posted / partha mitra
By welding the rod,and the welding should be in stagerred
type.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Explain what is Critical Path Method (C.P.M)?
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
How many Sft of Level Plaster per Kg
How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density
What are the common ways of demolition?
225 mm thick RCC slab, how many ton load slab can carry? for example if 33 ton truck loaded with soil, truck having 6 wheels. slab can take load or not? grade of concrete is M35 and slab design Fe500, slab desing one way slab.
Give list of building construction equipment & explain about them in brief. How much is output of JCB, POCLAIN, Steel cutting & bending machine, material hoist, tower crane?
can we use PPC for concrete wall, If yes, what is the concrete (PPC & OPC) grade for Non- load bearing concrete wall, load bearing concrete wall & for cellar retaining wall.
how to balance aggregate during mix design of concrete???? how to calculate moisture content like C/A,F/A and how many percentage using ice instead of water for example of we are preparing ice concrete??????
RR masonry rate analysis
How to produce the Concrete Grade 30mpa at 12hour? How to prevent for plastic shrinkage crack? How can we produce fire resistant concrete?
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
how calculate the bearing from two coordinates?
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
how many litres of enamel paint required for 5000 sft of site??
