why we use tapechanger in primary side of transformer
- 5 Answers
- 8208 Views
- Bhel, L&T, I also Faced
- E-Mail Answers
Answer Posted / koti
It is not primary, but HV side. For OLTC-above answer of
low current is OK. For Off-Ckt TC; more turns to get more taps, away from core i.e. near to tank which facilitate easy tap connections.
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
does a DG set has low fault level as compared to that of a transformer.If yes then why.
nwhat are the main Components of servo motor?
How to size Air Circuit breaker (ACB)? What is the most important factors?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
Make a list observation on Transformer?
how is capacitor bank look like
What is A check, B check, C Check & D check for a diesel Generat
why cable i burning without tripping. how can protect led street lights
what are factors to be consider to design a HT & LT motor?
How to calculate energy stored in an inductance?
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
What happen Grid EARTH plat got cut.
What conditions are required for transformer to operate at low frequencies ?
How shall i select the value of capacitor or inductor in a system?
how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take
