Answer Posted / naveen kumar
Mig, Tig, Arc, Spot, Gas,
Oxyacetyleen, Plasma Arc ,
recitance, Robotic, sheet
metal, solid state,
stinless steel, submerged
and laser weldings....etc
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
a rollin mill is spacified by
should cutouts made in main header of metal ducting be deducted from duct measurement.
hi friends pls send the bhel question papers is very urgent...
what is Retainer?
What is the weight of 1m3 of seawater?
Pls tell me the diff bw impulse turbine and reaction turbine
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
How to calculate heat load .For example 10 TR .Then how we will find load (we want rh(relatavie humidity) sir)
What is the principle of a pump?
8000 Liter Water in 80 degree Celsius will generated how many STEAM ?
what are the main problems of solar electrical systems? to make quality control on, which parameters that need so?
If the black box flight recorder is never damaged during a plane crash, why not the whole airplane made out of that stuff?
How is the aptitute test done
What does Nominal size in a valve means like NG6,NG10 etc
Hai, i am going to appear for Section Engineer- Mechanical,RRB Chennai.Can anybody please post me the previous question papers and solutions to ajeshsudhakaran@gmail.com....
