Interested to Buy Any Domain ? << Click Here >> for more details...
can we measure +,-.zero sequence current ....?
if so how can ???
- 2 Answers
- 4477 Views
- NLC, I also Faced
- E-Mail Answers
Answer Posted / vara prasad
these are not measurable these currents are assumption purpose
only
ex:if R phase opens sequence currents of R phase are not equel to zero
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how dose servo motor works
Define cuttoff frequency?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
how to determine Sq.mm size of finolex power cables.
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
help me with the question that might be ask on the interview for technical position
why ct ,cvt should be stored in a vertical position?
why we change the direction of winding in rotor ?how we make the north and south pole?
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
