what is fire and gas system?
Answer Posted / mohamed yousuf
fire and gas system is nothing but to detect the toxic,
flamable and combustible gases in the plant and also for
giving the awarness of the hazardous through beacons and
loudspeakers.
Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
what is the difference between attemperator and desuperheater ?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
What is the use of temperature compensation?
What is difference between ESD and PLC please Explain me clearly.
What is 3 selection available when configure the burnout protection for controller
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
How to calibrate level transmitter with use of HART?
Draw block digram for well head from well to shipping pump?
How can a d.p. Transmitter be calibrated?
Identification of ss fittings, pilot valves, relief valve.
how to check earthing,what is minum ohms for proper earthing
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
what is interlock system and why we use of this?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?