i am very much confused about direction of thrust in steam
turbine...we have steam turbine of 13 stages,10 stages of
impulse and 3 of reaction type....in study manual direction
of thrust is towards inlet but on thrust bearing its loading
side is towards condenser(exhaust side) wile also dummy ring
is present in design which also restrict rotor to move in
exhaust side direction not inlet ....
Answer Posted / noor mohamed
HI freind u mentioned that 3 stages were reaction type generally reaction type expansion is done for high pressure side of turbine (major axial thrust acting on this side) and impulse type expansion is done at Low pressure side and also thrust direction depends on the side at which the steam is entering and leaving.if u have any images of ur problem statement that ll give a clear picture Thanks
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Why can't we use antifrictional bearing in place of journal bearing in a 660mw plant
what is the trignometry of lifting tools using the wire rope ? any formula for trignometry ?
if any one who attended the caterpillar interview please send me the sample questions and the areas from which questions are being asked...
Properties of F.O. the cause damage on auxiliary boiler.
Which has the greater pressure in a stern tube sealing seawater or L.O.
What is isotropic material ?
What resistance the ship encounter when the vessel is at sea
Is a diesel engines maximum rpm limited by the diesel burn rate?
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
pl convey me the procedure to get the vat and cst no. i am going to start trading cum manufacturing of grain handling equipments.
Define the term latent heat.
What is the device that converts sound energy into mechanical energy?
Explain why is over-pressurizing an air conditioning system bad?
what do you mean by turbine droop?
The efficiency of a pin fin with insulated tip is