how do we calculate the quantity cement,sand, & aggregate
for M20,M15 for 10cum.
- 7 Answers
- 22939 Views
- Opera, Raheja, Star, I also Faced
- E-Mail Answers
Answer Posted / sridhar reddy
what piyash said is write but in place of water take fine aggreate
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
if 20mm aggregate is coming by weight 25 ton in a 10 wheeler hywa ,then what will be total volume of aggregate in cubic feet.
How can we demolish concrete beams?
In how many types u can do POP on ceiling and walls(on which material or by using which material)? b) what is the difference between dry , oil bound, enamel, acrlyic type of painting?
Give me an example of a time when something you tried to accomplish and failed.
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
What is the standard volume of pharma in cub ft
How many days should curing of plastering, brick work and concrete
What is the method of soil replacement test?
TO CONSTRUCT A 1800 SQFT CAPACITY UNDERGROUND WATER TANK HOW MUCH CUFT CONCRETE IS REQUIRED AND HOW MUCH REINFORCEMENT IS REQUIRED. FOR COSTING
Define What materials were used to build the Golden Gate Bridge?
What are the types of slump?
what motivates you to do a good job
can we find any technical issue if we are gong to change the dimensions of steel beams from one type to another type IE if there are any equievelant data base to find solution for problem of changeing sectios of beam from one type to another with the same cross sectional area.
how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?
How to do base isolation using ETABS software?
