an off load but energized 11/0.4 KV, 1250 KVA T/F has a
power factor of 0.65(capacitive)..!! why is it so, though
T/F being an inductive device ??
- 4 Answers
- 4682 Views
- I also Faced
- E-Mail Answers
Answer Posted / doss
if its a new transformer please check the test report done by site acceptence tan delta test .its should be the capacitance high ,and dessipation factor also need to check ...
if the result is high means need to check the winding...if the tan@ reading is less than 0.05 the transformer is good condition..so check external..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is metering cum synchronizing panel and how it is used?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
what is the voltage between earth to neutral in lift.
What are all present producing cost of Per KWH of various Fuel?
Difference between megger test equipment and contact resistance meter test instruments?
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
Is neutral transformer can be called as control transformer?
State the frequency for rc phase shift oscillator?
What is 11 N1 and 12 N2 in single phase Transformer ?
What is the different types of cable & current capacity of cable
what is meant by carrier aided trip protection in transmission line
i am trying to PSUs/govermeant jobs since last 2 years but still i m not success, plz help me.
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
i need some project topics along with circuit diagram in the electrical adnd electronics engg and also give ome website regarding projects.my mail id is thenmozhi2k7@gmail.com .please help me.
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
