What is the DIfferences between SMART transmitters and
PROFIBUS DP/PA Transmitters?
- 4 Answers
- 9460 Views
- I also Faced
- E-Mail Answers
Answer Posted / dibyendu das
PLC DCS
 Fast logic scan (approx. 10ms) is required to perform
motor or motion control.
 Control loops require deterministic scan execution.
perform motor or motion control at a speed of 100 to 500 ms
 Redundancy may not be cost justified.
 System redundancy is often required.
 System can be taken offline to make configuration.
 Online configuration changes often required changes.
 Analog Control: Simple PID only.
 Analog Control: Simple to advanced PID control up to
Advanced Process Control.
 Diagnostics to tell you when something is broken.
 Asset Management alerts you to what might break before
it does.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
Manipulation of dead wt. tester double piston type.
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
Why do we floating DC in DC system.
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
which type of zones used for boiler? & why ?
what is effect of specific gravity in differential level transmitter , explain formula related with this .
What is furnace draft control?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
which processor is used in dcs.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Isometric drawings are generated during _________________ phase of a project
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
how to calibrate and troubleshooting of leveltroll?
How to calibration coriolis flow meter?
