Answer Posted / *avi
Flux means nothing but some kind of line of force. Whenever
current flows through magnetic field causes the flux
production around that conductor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
v/f drive basic princeple
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
What are IR values and what it should be for coil and for insulator
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
in dc shunt motor if field winding is shorted then
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
pre arcing time of ehv breaker
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
what is the difference between elcb and rccb ?
