Interested to Buy Any Domain ? << Click Here >> for more details...
why induction motor always operate at lagging p.f.?
- 4 Answers
- 11107 Views
- I also Faced
- E-Mail Answers
Answer Posted / pintu sain
because emf produce due to induction always leg
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
should %impedance be high or low in a power transformer? if so why?
how does high earth to neutral voltage affects electronic circuit?
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
why do we use 25kv supply for traction purpose?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
What are the classifications of heating element?
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
WHAT IS VCB SAFETY
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
how can we select the appropriate VCB ?
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
