Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by H.R.C fuse?
- 40 Answers
- 205160 Views
- Gas Projects, GSCE, Taj Group, I also Faced
- E-Mail Answers
Answer Posted / mukesh kumar
High rupturable cartridge fuse
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
and gate circuit diagram,amplifier circuit diagram
what are the range of memory address in plc for L&T lx7 4A
can any one suggest paper presentation topies for electrical engg?
How earthing/grounding done in aeroplanes and ships.
Please define ohm’s law for a.c (alternating current)?
is oil viscosity affect on motor current?
how to find the capacitance value of the motor while running??
Why 11kv to be generated in generation station
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
