In 3 phase induction motor 1hp current rating is 1.5 amps
constant ? is correct or not ?
- 4 Answers
- 15176 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / pradyumna chandra panda
It is not justificable that current rating of 3ph motor is culculate to 1.5 amp per hp. Reactive power is more in higher size hp motor ie. slight less current per hp. And reactive power is less in lower size hp motor ie. more current per hp. Normaly 3ph 1hp motor take 1.8 amp per phase (phase current) Simiarily current rating of 3ph 5hp is 7.5 amp, 10hp is slight less then 15 amp and 100 hp motor is approximately 140 amp.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
Block diagram of Power line communication?
what does a string of resistors in a series will do?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
What is the function of the circuit breaker failure relay?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
HOW TO TEST A LIGHTENING ARREST ER ?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
How to set the relay,,??
why effective resistance should be more than static resistance in transmission line?
low frequency protection why recomend?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
