What will happen if induction motor is supplied with
capacitive load?
- 1 Answers
- 4539 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / tariq
It is quite clear that Poor load current phase angle is
generally the result of an inductive load such as an
induction motor, power transformer, lighting ballasts,
welder etc.
Specifically discussing the case of induction motor we often
use the bank of capacitor to improve the power factor. If
the motor is already being supplied by capacitive load then
it may be fruitful for the motor as well as for the whole
system but up-to some extent. The power factor on capacitive
side has also its own draw backs. The major is to increase
the thermal losses.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
what is the principle of operation of tungstun bulb ??
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
what is meant by 2 within a star in a voltmeter dial?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
how give earthing conection to household equipment?
what is the function of gss in the dg set.
What is cable tray, its type, and its support?
What is the type of earth fault protection used in battery? explain.
Is electro plating what type of load whether resistive, inductive or capacitive loads
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
Why we cant store an ac power. If we coo store in which device we can?
