Answer Posted / only_tarsem
Mortar life 4 hours only.
| Is This Answer Correct ? | 13 Yes | 3 No |
Post New Answer View All Answers
What is the l/d ratio of cantilever beam?
What is the difference between Grade I, II and III of GSB?
why +1 to be followed for calculating the no of bars in BBS. Please explain
what do you understand by M25 concrete
Why should pumping be not used in case of concreting works?
The largest size of paper used in plotter to print the drawing made by Autocad .
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
a butt weld is specified by
Please tell me vasthu room sizes. Thanks.
cement and sand required for one block of size 0.23*0.15*0.46
A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx
what will be the total emoluments for deputy surveyor in APPSC in the payband of ( 9460-27600). please give me the detailed information step wise?
pls mail some more tecnical qustions at msaranya2610@gmail.com
What is the difference between chamfer and fillet?
where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?
