Which type of power plant is more easier to produce electrical
power at economical condition?
- 5 Answers
- 7977 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / mayur
i think the question expects the most easiest and economic
way to generate electricity at the already established power
station.So the answer should be HYDRO ELECTRIC POWER STATION.
It must not be thermal,tidal or solar because they are not
available 24/7 or require further treatment on constituent
elements such as heating or conversion.
So go with the HYDRO ELECTRIC POWER STATION.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
what is (+) and (-) in generator field detector stand for?
Can an inverter be used as a converter? How?
Explain cos(theta) and Sin(theta)
What are two contours of nichols chart?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
Electrical Engineering
if i am in front of transmission line how to know that current direction without any equipment
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
how ceiling fan worked?
What is the working principle of servo motor? And explain it.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
why would amp draw on neutral wire be as much as amp draw on the hot leg.
how much allowable resistance that can be difference in motor all coils?
What is the problem of internal failure in ship engine telegraph system norcontrol?
