Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bharatgohel5314
Power transformers are used in transmission network of
higher voltages for step-up and step down application (400
kV, 200 kV, 110 kV, 66 kV, 33kV) and are generally rated
above 200MVA.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is meant by LCR meter? where its useful ?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
Why in ESP Positive earthed
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
what happen if drive input fail momentry at 48.5 HZ frequency?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
what is advertised hop count
Difference between earthing & grounding.?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
Why is negative feedback invariably preferred in closed loop system?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
what is difference between 5A and 100A CT constructional wise and operation?
what is the ms flat constant for calculating earth mat design calculation?
