What will happen 50 HZ motor when you will give 60 HZ?
- 7 Answers
- 8812 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / arvind kumar
As we all are aware with formule
NS=120f/P, if we change f(frequency) the syn.speed will
change as these quantities are directly proportional to each
other.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
If a high resistance fault occurs,then what are the changes will happen in the system?
in non technical way how can u define POWER FACTOR??
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
What is BusBar integrity test and how it is conducted?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
is there any phase difference occurs while primary and secondary side mutual induction occurs?
what is the electrical?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
Is there any standard guidelines/Criteria to design NGR/NGT.?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
how to operate and maintenance of 1500 kva diesel generator set
