what is the change over switch ,switch disconnector ,bypass
switch and switch disconnector fuse unit?
- 1 Answers
- 8495 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhanu
change over switch, which is used to change the source of
power, there are four connection points( terminals) in a
change over switch,Example:- you can connect DG power &
board power as input terminals then connect output
terminals to the load ( just like two switches inter
connected by mechanically or electrically, at a time one
switch will ON & other is in OFF position)
Switch disconnector/ switch disconnector fuse unit :- in
old days the main switches( SFU- Switch fuse unit) out put
terminals& fuses are mechanically connected when switch is
in OFF position but in SDF/SD when the switch is OFF
position there is no any connection between input/ out put
terminals & fuses.
Bypass switch - it is just like an ON/OFF switch , if any
auto linked circuit connections are failure you can use a
switch to make the circuit complete.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Generator,motor and alternator Working principal Please explain easily
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
In CTs tan delta point should be earthed , what is the reason behind it?
what type of motor used to move a 1 ton gate? and relate ratings with load.
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
is it possible to have dc motors on single chip
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
Why neutral is not used in three phases dol starter
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
if i am in front of transmission line how to know that current direction without any equipment
Give two basic speed control scheme of dc shunt motor?
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
