Interested to Buy Any Domain ? << Click Here >> for more details...
WHY HOLDING CONTACTOR OF MOTOR STARTER IS CALLED NO VOLT
COIL.
- 3 Answers
- 20216 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradyumna chandra panda
I WOULD LIKE TO ASK ABOVE QUESTION.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
What are the different types of controllers?
What is the difference between amorphous core transformer and CRGO core transformer?.
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
.php|
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
can anyone provide me a amf panel control wiring using ec-2 relay?
what are the stresses in circuit breakers ?
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
Why neutral point is consider as zero potential?
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
