I am gokul. i finished B.E(EEE). I have 2 years experience in
maintenance. But now i have not job, so i am searching. i want
any effective courses in Electrical field with related to job
and good salary. any one will help to me. please tell?
Answer Posted / sabir
Wat is NTPI?
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the formula of starting current of 3phase and 1 phase motor???
specific difference of ICT&Auto Transformer
how generator load test is conducted?what are the steps?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
what is the usage of microcontroller in the panel board?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
What is the purpose of stablization resistor in high impedance bus bar protection
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
how electrical earthing maintenance done in industry?
plese send me the oces/dgfs sylabus and previous year question pattern of electrical engg.?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
State kirchoff current law?