Answer Posted / parthasarathi
5P means actually the %error in the secondary of CT.
PS(purchaser specification) means, it is a special CT .
normally it is indicated like this EX : 5P20 means 20 times
of the over current the core will be saturated.
Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
How are load losses and no-load losses measured at site in a DG set?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
what will happen if synchronous machine rotor fed from single phase ac supply
how braking & making capacity of circuit breaker is calculated?
how to calculate current and voltage in a same circuit?
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
Describe the test procedure to determine the vector group
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Why negative feedback is preferred in the control system?
What is meant by control system?
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
1.What will be stored in online ups EPROM IC?