in which code refer the change of reinforcement dia defer to
drawing . i.e. 12mm dai into 16mm dia.
- 3 Answers
- 5220 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
IS 456:2000
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What was asked in isro civil interview
How to find permissible diagonal tensile stress in reinforced brick work
can you give me the details of rate analysis of steel and concrete?
RR masonry rate analysis
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
what is anchorage length,lap length and (dont remember the last one)
what is the difference between np2 and np3 concrete mix
What happens when water mixed with cowdung is used for priming instead of water for lifting water in pumps?
Define What is diversion tunnel in a dam?
what is the ingredient value of 40mm and 20mm aggregates?
HOW MANY BAGS OF CEMEMT USED IN PER M2 OF PARTITION WALL
rimmer in pile foundation
why do we not deduct volume of steel to find actual volume of concrete in practical???
What happens to Load at yielding ?
Explain the various stages of the project planning process in construction?
