Answer Posted / m.anand
copper loss and iron loss depends only on current and
voltage there is no phase angle involved in between voltage
and current.so powerfactor is not factor affecting
transformer rating ...
hence transformer ratings are in KVA
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Which device is used for the source of emission of electrons in a crt?
what is Fault level? why it is calculated? how will u decide same for our plant?
Phase control and integral control are used for?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
does buccholz in a transformer use batteries
TYPE'S OF BREKAR ,WHAT IS TRANSFORMAR & SAFTY. STARTER DOL & STAR DELTA STARTER.
What are dependent sources?
what is servo motor and how it works?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
what is acceptance test in electrical engineering.
How can we checked Killo Watts of Motor & Alternator?
What is the main cause of magnetism?
in non technical way how can u define POWER FACTOR??
what is basic difference betmeen normal & flame proof motor??