what is exiter winding,stator winding,avr?how it will work?
- 1 Answers
- 3894 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / praha tuty
Exciter winding- It is a field winding in the rotor of
alternator.
Stator winding- It is a winding in a stationary part of the
alternator.
AVR- Automatic Voltage Regulator. To control the speed of
the rotor by regulating the exciter.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
why you don not show protection and type of isolation in key single line diagram?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
how to calculate IR value of 33KV cable ??
EXPLIAN THE IMPORTANCE OF POLY PHASE CIRCUIT.
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
for 750 kw LT load what will be the ht kva
why not starting switch first connect in direct on line starter?????
hi , i have 150 kw loud and we need 50 m cabil,i want to know wich size cabil we use. thanks
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
how give earthing conection to household equipment?
Earth bits close or open. Which is correct
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
Why increase in current leads to increase in conductor temperature?
