Answer Posted / subhas reddy
15 watts for sure
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is George phenomena to start the synchronus machine?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
CALCULATE THE TOTAL VOLTAGE DROP AND SELECT THE CABLE SIZE IN MM-SQARE FOR A PANEL-262KW AT 110 METER FROM THE SOURCE SUPPLY , SUPPLY VOLTAGE 240/415
What is the Minimum winding resistance of motors ( small & big)? referance range
what is proper capacitor placement? How to evaluate capacitor size?
Can i use the B-curve MCB instead of C-curve MCB
how do you test tachos and servos
how you configure motorvision relay (L&T make)from DCS
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
why are the maintaine power factor and how can this control and this is how work.
What are the application of filter?
How to calculate the sag of OPGW during stringing???
Why field rheostat is kept in minimum position?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
