Answer Posted / vijay patel
We Can improve power factor (1)by using shunt capacitors (2)
By using phase advancer (3)by using synchronous condenser
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
I need bhel electrical test pattern & paper
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
What is the basic of DTH.
Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.
Difference between low impedance and high impedance Restricted Earth Fault
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
what is a bus post insulator? explain its application in a substation.
how can i find cable size from current rating?
what type of questions are asked and howmwny questions belong this catagory?
what is the pre charge circuit,what will be work which function it will be use plz tell me
What is cable tray, its type, and its support?
