Interested to Buy Any Domain ? << Click Here >> for more details...
how many bulb of 60watt at 300volt is used to maintain 0.25
amp.with valid reason?
- 4 Answers
- 6257 Views
- Cords Cable, TATA, I also Faced
- E-Mail Answers
Answer Posted / ramamurthy
20 of them
4 groups of lamps in series, with each group having 5 lamps
in parallel
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
how test transfomer(3 phase75kva) by megger
What is the ratio of true power to apparent power in an ac circuit?
what type of questions are asked and howmwny questions belong this catagory?
Iin ESP why positive is grounded ? why not negative ?
Motor,transformers,capacitor tubelight etc....
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
What is called grain-oriented laminations?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are the commonly used schemes for the bus zone protection?
why the NGR (neutral grounding resistor) always OFF during DG off?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
Enlist four components of electrive drives.
If one lamp connects between two phases it will glow or not?
AL=0B9H,bl=75H, ADD AL,BL AL=____________? CF________? OF___________?
