Interested to Buy Any Domain ? << Click Here >> for more details...
why we done superheated steam in to saturated steam.
- 4 Answers
- 7240 Views
- ABSC, I also Faced
- E-Mail Answers
Answer Posted / majid
for incresing efficiency
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
What are the causes of damage to propellers?
Where can you find space heater lam p and what is its purpose?
Ultimate analysis of coal is elementary analysis. What it is concerned with ?
How many types of oil spilling available?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What are the different types of brakes?
What are the causes if one cylinder in a diesel engine has a high temperature?
What will you do when scavenge fire happened?
Why preferred Production than Drilling?
Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?
What are the two basic types of steam turbines?
in aviation, How does control valves work?
What are the advantages of dtsi over normal engines?
i m a 1st year student my senior asks me 2 give intro wht will a impressive answer
How many mechanical engineers work with you at your place of employment?
