where transformer is installed?
a)generating station
b)substation
c)voltage regulating area
Answer Posted / sanjay
transformer is used in
1-genrating station(step up)
2-substation(step down)
3-transmission line(booster)
thus transformer is used where voltage is required at
desired level.
for above one answer (c) seems to be d right one.
Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
I Want randstand placement papers
how can i change the rotation of the AC single phase induction motor and show me by diagram
What is the classification of hydro projects based on installed capacity?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
Please nybody say, weather the result of Bharat Oman is declared or not? Probable date of declare???????
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
What is the automatic voltage regulator with servomotor?
How do apply electrical 'c'license......pls advice
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
what is (+) and (-) in generator field detector stand for?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
Name of the relay of low lub oil presuure in DG sets