Answer Posted / arpita
snubber circuit is someting like a "bumper." It alleviates the rise of voltage when the switch of scr/transistor is turning OFF, and alleviates rise of current when the switch of scr/transistor is turning ON, to a safe level.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is KV and XV valve
what effects a surging can produce in the compressor
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
What are the type of bonnets in the control valves?
What is the procedure of calibration of Load cell?
What is the reason PT speed not incresed in gas turbine?
Speedtronic system .
what about your moleg in pogrees with company
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
can you provide me full detail about instrumentation in ONGC??
Manipulation of dead wt. tester double piston type.
What is the main difference between Cavitation and Flashing?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
What is the purpose of the analyzer in petrochemical plant?
