Answer Posted / chandraveer singh
In Orifice Plate Thera are Two Holes.One Is In Upper Side
And Another One Is In Bottom Or Lower Side.
Upper Side Hole- Also Called Vent Hole ,Used When Liquid
Services Is there for Removing Any unwanted Gas traps.
Bottom Side Hole- Also Called Drain Hole ,Used When Steam
Services Is there for Removing Any unwanted liquid or any
oil contaminant or steam condensate.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
please send the drdo exam paper
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
what is the procedure of O2 sensor(ABB) calibration?
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
send me last 5 years questions asked in rrb chennai, for section engineer
In turbine what does term CDP, NH, HSSOC means.
Specify for Cables - Flame Retardant and Fire Resistant?
Explain Gas Turbine startup and shutdown sequences
How r the calculation of process line mpm.
How will you calibrate PID controller? explain with example.
What is 3 selection available when configure the burnout protection for controller
How to work temperature gauge?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
