Which standard describes the tolerance limit for undulation
of RCC wall/ after POP surface?
- 1 Answers
- 5205 Views
- I also Faced
- E-Mail Answers
Answer Posted / sjtbehera
IS: sp-34
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Mention different types of roof systems?
Whats the meanig of ,'K' VALUE in the case of soil.....
rate analysis hiring of generator 62.5 KVA
What is OSHA compliance?
In Rcc ratio calculation I wanted to know quantity of Steel also.
how to create our resume?
Currently my house construction is going on but we just realized that the portico earth beam couldn't connect with the original earth because the beam rod not extended so Please advice
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
HDPE pipe standard bends using for TSE irrigation? is it possible to use 30 degree?
What is thumb rule in quantity and cost estimation of a residential building in civil engineering??
Please let me know what is the simplest way of Calculating Mix Designs
hoe much fine & sourse agregate required for concrete mix of 1: 1.5:3 by volume in Cu.Ft
What is Gsb tollens ?
How to calculate(Thumb rule) the consumption of steel per cubic meter for different concrete members.
What is the difference between tor steel and tmt steel?
