Answer Posted / malay kumar
THE MAIN POINT IS DUE TO EXCESSIVE HEAT, THE REASON MAY BE AS LOSS CONNECTION,CONTAMINATION OF TRF. OIL WITH MOISTURE,WITH NOT PROPER COOLING, AND EXCESSIVE LOAD.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
State The Difference Between Generator And Alternator?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
what is the purpose of silicon dropper used in battery charger?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
What is the abbreviation of NGT panel
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
If short circuit ratio is high is it bad or good for a machine then tell the reason...
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
how to control the speed to switched reluctance motor
how to decide choke rating for drive?
The size and construction of bushings in a transformer depend upon?
explanation of mesh bus bars
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
control & auxilary circuits used for circuir breakers
