Interested to Buy Any Domain ? << Click Here >> for more details...
Hi in PCB design what the formula for the trace with
calculation.
- 9 Answers
- 20628 Views
- LinkWell, I also Faced
- E-Mail Answers
Answer Posted / anandhan k
Hi
This is depending on the copper wight, current rating and
the transmission line location (outer layer or inner layer)
Trace will reduce half when you increase the copper wight double
Anandhan K
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What were vacuum tubes used for?
what is transmission ?how transmission is done in nokia 3G?
On what parameters does the free running frequency of vco depend on?
Define why r-c filters are suitable only for light loads?
List out the direct type adcs.
what is the difference between isdn and idn?
State different methods of voltage control inverters. Describe about pwm control in inverter?
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
What is the distance from an RF Transmitter that output power is determined?
What is the necessity of heat sink?
HOW CAN I WRITE the SCENARIO , USE CASE , Hierarchical Task Analysis AND PLAN FOR ATM ? URGENT
how do link aT1 from the 1st BTS to 2nd BTS4?
Explain what is an fpga?
What is working principle of profibus and how it transfer data?
where do i get exercises for electronic circuits lab, i.e, designing various waveform(clipper, clamper, rectifiers)
