Answer Posted / mahesh chaudhari
Generally its 5 to 6 times than that of rated specified
current on motor name plate.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
how is the connection of a 3 phase ct trivector meter done on a pole mounted transformer
How line capacitance & line inductance varies with increase in height tower.
I want to know Electrical Circuit?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
What is called grain-oriented laminations?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
diff. between tension mode & speed mode
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
Mention the difference between Analogue and Digital circuit?
advantages and disadvantages of inverse definite minimum time RELAY
Is it possible to measure the voltage of a battery from a single terminal?
