i have level transmitter -400 to 0 range
for steam drum application
but i am unable to calibrate
if installation of lt below lower tap what
will be the effect ?
and as per std wht is location of
lt ,above lower tapping or below
Answer Posted / saurabh
You have to install lower tapping on higher side and upper
tubing at lower side
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
can we copy the software from a transmitter using hht(hart 275) ?
Definition of reverse and acting controllers:
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
What is ultrasonic flowmeter?
Why do you want to work here
If we increase only P what will be controller action ?
Why thermo wells are used? What materials are used in thermo wells?
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),