I am pujita completed Electronics and Instrumentation
Engineering.As a fresher i am going to attend the
interviews.Could anybody guide the topics/questions covered
mostly in interviews.
- 11 Answers
- 20594 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.thangadurai
HAI, PUJITA. YOU DID KNOW WHAT IS ELECTRONIC,CURRENT,VOLTAGE,CAPACITANCE ETC...THEN WHICH TYPE OF SYSTEM USING IN FACTORIES IE, PLC,DCS...ETC.HOW TO WORK THIS TYPE OF SYSTEM...
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Which topics are covered in Process Control?
whats the abbreviation of IOP? is it instrument of power or input open problem?
defination of radial vibration?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
what is diffrance between FF & SMART, explain with difination
ORP sensor working principle?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
what is the difference between scaler and vector drive
How to calibrate Magnetic flow Transmitter in Field
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
