Interested to Buy Any Domain ? << Click Here >> for more details...
explain Cascade Control strategy with the help of a block
diagram. also exlain its working in a distillation column
- 2 Answers
- 11778 Views
- ABB, Sabic, I also Faced
- E-Mail Answers
Answer Posted / amit123.inc
Dear Inbu Raja E K-Actually the output of the primary controller is used as the reference or setpoint for the secondary controller.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
How d.p. Transmitter can be applied to open tank?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
how to calibrate load cell
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Differentiate between ultrasonic flowmeter and radar type flow meter
What is the start up procedure of desalter
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
what effects a surging can produce in the compressor
Please can anybody help for control valve sizing step by step procedure?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
What is voltage regulator?
NSV type probe stands for
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
