how many number of terminals are available in CURRENT
TRANSFORMER
Answer Posted / prasun
6 terminals.
| Is This Answer Correct ? | 2 Yes | 7 No |
Post New Answer View All Answers
How much load can be taken for chiller from 1500 kva transformer
What is EMC filter in VVVF Drive ?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
what is the chiller and working principal
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
battery capacity use of made?
Which capacitor is preferred for high voltage and frequency?
why generator efficiency is more in swinburnes test?
What is dc current source? Differentiate between ideal and non ideal current sources?
Difference between transition and diffusion capacitance
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how to test the electrical panel.ht lt mcc pcc.