IF 125 kva diesel generator generating 13 kw energy in an
hour then how much percentage of load is connected to
generator and generator is running at what load efficiency
- 2 Answers
- 4318 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravindra dashore
10.9 % - Its depence on type of load & poweer factor alos
depence on load.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
If any machinery or trnsmission needs periodic and regular lubrication what is the best method to give?
Give five reasons why a reciprocating pump will reduce capacity or pressure when delivering water
AS I AM BEING IN PLANT ENGINEERING & MAINTENANCE DEPARTMENT I WANT ANY BOOKS RELATED TO MAINTENANCE CAN YOU GUIDE ME THE AUTHOR.
what is the basic optimal difference among isothermal,isentropic and adiabatic processess( with charts of each)??
How does a boat measure speed?
Discuss venturimeter?
any one have amw(ASIAN MOTOR WORKS) QUESTION PAPERS OF PREVIOUS PLS SEND ME AT mahendra_yalavarthi@yahoo.com
Greetings This question is about hydraulics and I request an expert to answer it. A simple hydraulic machine is made up of two heads, a larger one with a larger force inside a wider pipe and a smaller one with a smaller force inside a smaller pipe in width as in the second picture on this link: http://science.howstuffworks.com/hydraulic1.htm The question is this: what happens if the smaller head and the smaller force doesn’t exist but the smaller pipe is high enough to take all the liquid? For example the larger head is 1.00 sqr metre and can go down 1.00m under a weight of 100.00kg. The cross sectional area of the smaller pipe is 0.001 sqr metre. Now when the larger head goes down 1.00m, how high the liquid from the wider pipe can go into the smaller pipe of the cross sectional area of 0.001 sqr metre? Regards
What is the most important thing you have achieved as an engineer?
• Why not 4 phase & 5 phase
How can be calculate discharge of id fan. impeller dia-800 mm,motor capacity 10 hp 2800 rpm,blower opening section 230*130 mm
what is run out? how to calulate run out vaue.
Why tampering to be done?
Can I use IS 2062 GR B Material for low temperature application upto -20 C ?
What are you going to inspect or check when you open the crankcase?
