how to calculate busbar size?
if ex:1000amps i need to calculate busbar size and what size
of bar?if any example caculation pls give the formulas.
- 2 Answers
- 4728 Views
- I also Faced
- E-Mail Answers
Answer Posted / chintu
AS per CPWD spec, Copper Bus bars are rated not to exceed current density of 1000A per square inch of cross section and Aluminium bus bars not to exceed 800A per square inch.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
What happens when ac supply is given as excitation voltage instead of dc supply
Which standard we are following earthing resistance test
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
why u r living from presentaly working.
Transmission through a short line depends on
what are the breakdown voltage rating of mini- curcuit'transfarmer!
what r the safety measures in UPS ? explain all?
what is meant by skew width in machines?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
where was current transformer protection units used and why??
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
